Step 9 Before Lighting The Appliance - Quadra-Fire QVI-25FB Installer's Manual

3. Attach the low voltage wires to the ON/OFF switch lo-
cated on the front of surround.
4. Attach surround assembly by securing four corners with
screws provided (see Figure 13.) Reposition the appli-
ance if necessary. Refer to surround instructions provid-
ed with the decorative surround.
12"
MAX.
12" MIN.
TOP OF UNIT
Figure 14
Figure 14 shows the minimum vertical and corresponding
maximum horizontal dimensions of mantels or other com-
bustible projections above the gas appliance.
18
MANTEL
Quadra-Fire • QVI-25FB • 2031-900 Rev. F • 9/07
Step 9. Before Lighting the Appliance
Before lighting the appliance, be sure to do the following:
Remove all paperwork from the appliance.
Review safety warnings and cautions
• Read the Safety and Warning Information section at
the beginning of this Installers Guide.
Double-check for gas leaks
• Before lighting the appliance, double-check the unit for
possible gas leaks.
Double-check vent terminations for obstructions.
• Before lighting the appliance, double-check the unit for
possible obstructions that could be blocking the vent ter-
minations.
Double-check for faulty components
• Any component that is found to be faulty MUST BE re-
placed with an approved component. Tampering with the
appliance components is DANGEROUS and voids all war-
ranties.
A small amount of air will be in the gas supply lines. When
first lighting the appliance, it will take a few minutes for the
lines to purge themselves of this air. Once the purging is
complete, the appliance will light and will operate normally.
Subsequent lightings of the appliance will not require this
purging of air from the gas supply lines, unless the gas
valve has been turned to the OFF position, in which
case the air would have to be purged.
NOTE: The appliance should be run 3 to 4 hours on the
initial start-up. Turn it off and let it cool completely. Remove
and clean the glass. Replace the glass and run the appliance
for an additional 8 hours. This will help to cure the products
used in the paint and logs.