Step 7 Installing Logs And Ember Material; Shutter Settings; Positioning The Logs; Placing The Ember Material - Quadra-Fire QVI-25FB Installer's Manual

Step 7. Installing Logs and Ember Material

Shutter Settings

Burner
___________________________________________
QVI-25FB
___________________________________________
Removing the Glass
Open access panels located on either side of the glass
door. Pull and release attachment latches at left of glass
door out and away from appliance. To reinstall glass, hook
right side tabs behind attachment brackets (right), swing
glass door into position, and secure by latching the tabs
on left side (see Figure 11).

Positioning the Logs

The logs have been packaged separately. Refer to the
installation instructions that accompany this manual. Save
the log instructions with this manual.
If sooting occurs, the logs might need to be repositioned
slightly to avoid excessive flame impingement.
Figure 11. Glass Assembly
Step 8. Installing Trim
Surrounds
Combustible materials MUST
NEVER overlap onto the front
face.
1. Find the coiled low voltage wires
attached to outer right side of
the insert (see Figure 13).
2. Disconnect the ON/OFF switch
from the low voltage wire leads,
and insert the ON/OFF switch
through the hole at the upper
right corner of the surround - it
will be retained in the hole.
NG LP
7/16" Full Open
GLASS
ASSEMBLY
PULL TO
RELEASE
(LEFT SIDE)
GLASS LATCH
TOP VIEW
Figure 13.
Quadra-Fire • QVI-25FB • 2031-900 Rev. F • 9/07

Placing the Ember Material

Two separate bags of ember material are shipped with this
gas appliance. The bag labeled Glowing Ember (050-721)
is standard glowing ember material. To place the ember
material:
• Remove the glass door from the unit.
• Place a dime size piece of GLOWING EMBER mate-
rial near port holes in burner top (see Figure 12).
• Space dime size ember pieces about a 1/2 inch apart.
Never press embers into burner ports. DO NOT cover
burner ports. Place dime size pieces around front and
sides of burner pan.
• Save the remaining ember materials for use during appli-
ance servicing. The embers provided are sufficient for 2
to 4 applications.
• Place MYSTIC EMBERS over burner surface and around
base of the burner, DO NOT cover any burner port holes.
Can be used on floor of firebox for a realistic ash-bed.
• Replace the glass door on the appliance.
• Re-install and latch the decorative front.
EMBER
PLACEMENT
Figure 12. Placement of the Ember Material
ON/OFF
SWITCH
SURROUND
WITH TRIM
BURNER PAN
FIREBOX
17