Fuel Specifications; Before Lighting Appliance; Controls - Quadra-Fire HUDBAY-FS Owner's Manual

B. Fuel Specifications
WARNING! Risk of Fire or Explosion! Appliance must be
set up for compatible gas type!
• This appliance is designed to operate on either natural gas
or propane. Make sure the appliance is compatible with
gas type selected for installation site.
• Conversions must be made by a qualified service technician
using Hearth & Home Technologies specified and approved
parts.
!
Glass door must be in place when appliance is
operating.
Risk of:
• Combustion Fumes
• Fire
Do NOT operate appliance with glass door
removed.
• Open viewing glass for servicing only.
• Glass door MUST be in place and sealed before
operating appliance.
• Only use glass door certified for use with
appliance.
• Glass replacement should be done by qualified
technician.
DANGER
!
HOT GLASS WILL CAUSE
BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
A barrier designed to reduce the risk of burns
from the hot viewing glass is provided with
this appliance and shall be installed for the
protection of the children and other at-risk
individuals.
!
Do NOT use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control which has been under water.
8
WARNING
WARNING
Quadra-Fire • Hudson Bay • 3-90-7003998_R25 • 07/17
C. Before Lighting Appliance
Read this entire manual prior to using the appliance. Failure
to follow the instructions may result in property damage,
bodily injury, or even death.
• Remove all shipping materials from inside and/or
underneath the firebox.
• Review proper placement of logs, mineral wool.
• Check the wiring.
• Check the baffle adjustment.
• Ensure that there are no gas leaks.
• Ensure that the glass is sealed and in the proper position.
• Ensure that the flow of combustion and ventilation air is
not obstructed (front grilles and vent caps).
D. Controls
Fan Speed: This knob controls the speed of the blower that
pushes the heated air into the room.
Main Burner: This control is used to turn the appliance on
and off.
Pilot Ignitor: The pilot ignitor is used only to start the pilot.
When the valve control knob is turned to the pilot position
and fully depressed press the piezo ignitor repeatedly
creating a blue spark directly next to the pilot, igniting the
pilot flame.
Valve Control: This knob is used to control gas to the
appliance and for starting the pilot. There are three positions,
ON, OFF, & PILOT. The indicator on the valve indicates the
position of the knob.
Comfort Control: This knob controls the flame height from
low ("LO") to high ("HI").
NOTE: If using a remote control wall switch, or thermostat,
the On/Off Switch must be left "OFF". Turning the On/Off
Switch to "ON" will keep the appliance on continually.
!
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this appliance
and shall be installed for the protection of children
and other at-risk individuals.
If the barrier becomes damaged, the barrier shall
be replaced with the manufacturer's barrier for this
appliance.
Clothing or other flammable material should not be
placed on or near the appliance.
Any safety screen, guard, or barrier removed for
servicing an appliance must be replaced prior to
operating the appliance.
WARNING