Fuse Replacement - Mercury 200 Operation And Maintenance Manual

d
a - Special washer head bolt (10‑849838)
b - Flat washer (2)
Description
Special washer head bolt
Nylon insert locknut "d"
Nylon insert locknut "c"
Assemble steering link rod to steering cable with two flat washers and self‑locking nylon insert locknut. Tighten
locknut until it seats, then back nut off 1/4 turn.
Assemble steering link rod to engine with special washer head bolt and self‑locking nylon insert locknut. First torque
bolt, then torque locknut to specifications.

Fuse Replacement

IMPORTANT: Always carry spare 5 and 20 AMP fuses.
The electrical wiring circuits on the outboard are protected from overload by fuses in the wiring. If a fuse is blown,
try to locate and correct the cause of the overload. If the cause is not found, the fuse may blow again.
Open the fuse holder and look at the silver colored band inside the fuse. If band is broken, replace the fuse. Replace
fuse with a new fuse with the same rating.
MAINTENANCE
a
c -
d -
Nm
27
27
Tighten until seats, then back off 1/4 turn
39
c
ob00676
Nylon insert locknut (11‑826709113)
Nylon insert locknut (11‑826709113)
lb. in.
b
lb. ft.
20
20