Table of Contents
Advertisement
2.
Open fuel tank vent screw (in filler cap) on manual venting type fuel tanks.
3.
Squeeze the fuel line primer bulb several times until it feels firm.
4.
Set the lanyard stop switch to "RUN" position. Refer to General Information ‑ Lanyard Stop Switch.
5.
Shift outboard to neutral "N" position.
NOTE: It is not necessary to use the neutral fast idle speed feature on the remote control to increase engine
speed for starting and warm up. The electronic starting system will automatically increase idle speed for starting
and will reduce it as the engine warms up. The engine does not require you to actuate the primer (choke) for
starting. The electronic starting system will automatically prime the engine.
6.
Turn the ignition key to "START" position. Release the key when engine starts. If engine fails to start in 10
seconds, return the key to "ON" position, wait 30 seconds and try again.
OPERATION
ob00347
ob00348
ob00349
ob00350
N
ob00351
33
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
