Mercury 200 Operation And Maintenance Manual page 48

5. Pull propeller straight off shaft. If propeller is seized to the shaft and cannot be removed, have the propeller
removed by an authorized dealer.
6. Coat the propeller shaft with Quicksilver or Mercury Precision Lubricants Anti‑Corrosion Grease or 2‑4‑C
with Teflon.
Tube Ref No.
Anti-Corrosion Grease
94
2-4-C Marine Lubricant
95
with Teflon
IMPORTANT: To prevent the propeller hub from corroding and seizing to the propeller shaft (especially in salt
water), always apply a coat of the recommended lubricant to the entire propeller shaft at the recommended
maintenance intervals and also each time the propeller is removed.
7. Flo‑Torq I Drive Hub Propellers ‑ Install forward thrust hub, propeller, continuity washer, rear thrust hub,
propeller nut retainer, and propeller nut onto the shaft.
a - Propeller nut
b - Propeller nut retainer
c - Rear thrust hub
8. Flo‑Torq II Drive Hub Propellers ‑ Install forward thrust hub, replaceable drive sleeve, propeller, thrust hub,
propeller nut retainer and propeller nut onto the shaft.
MAINTENANCE
Description
a b c
d
ob00377
ob00378
Where Used
Propeller shaft
Propeller shaft
e
f
ob00382
d - Continuity washer
e - Propeller
f - Forward thrust washer
42
Part No.
92-802867Q1
92-802859Q1