Silicon Graphics Octane2 Duo Installation Manual page 69

Hide thumbs Also See for Octane2 Duo:

Table of Contents

007-4506-001

5. Position the XIO board at an angle to the can, so that the tip of the can's applicator is

1 to 2 inches away from the ﬁrst (topmost) row of pads. Do not allow the applicator

to touch the pads. When you spray, the air hits each pad and ﬂows downward.

6. Start spraying. As you spray, move the spray along the length of the connector until

the entire length has been sprayed. Move down a few rows and again spray along

the entire length.

Note: Do not shake the can. Stop spraying if any visible material (for example, foam)

appears. This foam will blow away once you resume spraying just air.

7. Repeat until all the pads have been sprayed.

8. When you ﬁnish, cover the compression connector with its cap or immediately

install the board in an XIO slot.

Guidelines for Cleaning Compression Connectors

Table of Contents

Need help?

Do you have a question about the Octane2 Duo and is the answer not in the manual?