Appendix A: Reporting Codes - DSC NT9005 V1.0 Installation & Programming Manual

The following tables contain Contact ID and Auto-
matic SIA format reporting codes. For more informa-
tion on reporting code formats, see section [360] to
[381]. For more information on individual reporting
codes, see sections [320] to [353] .
Contact ID
The first digit (in parentheses) will automatically be
sent by the control panel. The second two digits are
programmed to indicate specific information about
the signal.
For example, if zone 1 is an entry/exit point, you could
program the event code as [34]. The central station
would receive the following:
*BURG - ENTRY/EXIT - 1
where the "1" indicates which zone went into alarm.
Section # Reporting Code
[320] to Zone Alarms
[323]
[324] to Zone Restorals
[327]
[328] Duress Alarm
[328] Opening After Alarm
[328] Recent Closing
[328] Cross Zone (Police Code)
Alarm
[329] [F] Key Alarm/Rest.
[329] [A] Key Alarm/Rest.
[329] [P] Key Alarm/Rest.
[330] to Zone Tamper/Restoral
[337]
* A/R = alarms/restorals; T/R = tampers/restorals; O/C = openings/closings; MA/R = miscellaneous alarms/restorals;
***Program the "Fail to close" event code [(4)54] to report either closing or activity delinquency. Make sure your central
†If unit is to be used in home health care applications, the unit must have medical keys
48
Appendix A - Reporting Codes
Code Sent When...
zone goes into alarm
alarm condition has been restored
duress code entered at keypad
system disarmed with alarm in memory
alarm occurs within two minutes of system arming
two zones on the system go into alarm during any
given armed-to-armed period (incl. 24Hr zones)
Keypad fire alarm (alarm and restore reporting
codes sent together)
Keypad auxiliary or medical alarm† (alarm and
restore reporting codes sent together)
Keypad panic alarm (alarm and restore reporting
codes sent together)
zone is tampered / tamper condition restored
****Zones are identified, panic pendants, wireless keys, and handheld keypads are not.
SIA Format - Level 2 (Hardcoded)
The SIA communication format used in this product
follows the level 2 specifications of the SIA Digital
Communication Standard - October 1997. This format
will send the Account Code along with its data trans-
mission. The transmission would look similar to the
following at the receiver:
N Ri01
Ri01
Dialer
Direction*
A/R
A/R
A/R
A/R
A/R
A/R
A/R
A/R
A/R
** UU = user number (user01-42); ZZ = zone number (01-32)
station is aware of the application of this reporting code.
BA 01
N = New Event
= Area Identifier
BA = Burglary Alarm
01 = Zone 1
Automatic
SIA Auto Rep
Contact ID
Codes**
Codes
(1) 3A See Table 3
(1) 3A
(1) 21 HA-00
(4) A6 OR-00
(4) 59 CR-00
(1) 4A BV-00
(1) 15 FA-00/FH-00
(1) AA MA-00/MH-00
(1) 2A PA-00/PH-00
T/R (1) 44 TA-ZZ/TR-ZZ
T = test transmissions
not auxiliary
( ) (
keys.
)