Xerox Phaser 3117 Service Manual page 69

3.Separate the fuser by unscrewing 4 screws on the
frame.
(Screw x 4:Gold_M3,6003-000269)
5.Separate the Exit roller F/Down and the exit gear
(DRV17)by turning the left/right holder connected to
the exit roller F/Down to the arrow direction.At this
time,roller_main,roller_FR, F/Down Holder,and
spring are separated with theses.
Exit Gear
Exit Roller F/Down
Roller_FR
Roller_Main
F/Down Holder
Note : Under the condition that the fuser is connected to the frame,the exit roller F/Down can be separat-
ed.However,be careful that the Roller_Main,the Roller_FR,and F/Down Holder could get into the inner
frame due to the spring' action.
x
4.After removing the Lamp Cover L/R, separate the
Fuser
6.Remove the thermo cap by releasing 2 screws as
Holder
Disassembly and Reassembly
Fuser Dummy cover.
Lamp Cover_R
Fuser Dummy Cover
shown as below.
(Screw x 2:Black_M3,6003-000282)
Thermo Cap
Lamp Cover_L
Service Manual
5-9