Xerox Phaser 3117 Service Manual page 67

5.2.7 RX Drive
1.Before Disassembling
-Separate the font cover.(Refer to 5.2)
-Separate the SMPS cover.(Refer to 5.3)
-Separate the Main cover.(Refer to 5.4)
3.Remove the connector from the separated RX drive.
Note:
x
RX Drive
Please, be careful not to touch the protruding 4 screws at the
outside of the RX drive.
2.Release 2 screws (Screw x 2:Silver_M3,6001-
000130)connected to the engine shield and 6 screws
(Screw x 6:Gold_M3,6003-000296)connected to the
frame. Separate the RX drive by pulling it out toward
the arrow direction.
4.After removing the RX drive,RDCN Gear, OPC Gear,
Fuser Gear, and Feed Gear can be removed from
the frame.
RDCN Gear
OPC Gear
Feed Gear
Disassembly and Reassembly
Fuser Gear
Service Manual
5-7