Control Panel (Electronic); Control Panel (Mechanical); Interlock Assembly - Maytag ALD510D Service Manual

Disassembly Procedures
!
WARNING

Control Panel (Electronic)

1. Disconnect power to oven.
2. Remove outer case, see "Outer Case" procedure.
3. Disconnect and label wires from control board.
4. Open oven door.
5. Remove screw securing ground strap.
6. Remove screw securing control panel to cavity. Lift
control panel up and out to release tabs.
Touch
Panel
7. Remove screws securing control board to control
panel.
8. Replace component and reverse procedure to
reassemble.

Control Panel (Mechanical)

1. Disconnect power to oven.
2. Remove outer case, see "Outer Case" procedure.
3. Disconnect and label wires from control.
4. Open oven door.
5. Remove screw securing control panel to cavity. Lift
control panel up and out to release tabs.
Control
Panel
Power
Knob
Timer
Knob
©2006 Maytag Services
Control
Panel
Control
Board
Flat
Spring
Knob
Coupler
Timer
Timer
Coupler
16026969
To avoid the risk of electrical shock, personal injury, or death,
disconnect power to oven and discharge the capacitors before
following any disassembly procedure.
6. Remove timer knob from timer.
7. Remove screws securing timer to control panel and
remove timer.
8. Remove timer couple from timer.
9. Remove screw securing knob coupler and flat spring
from control panel.
10. Replace component and reverse procedure to
reassemble.

Interlock Assembly

Primary switch is operated by the top latch arm.
Interlock Switch Removal
1. Disconnect power to oven and remove outer case,
(see "Outer Case" procedure).
2. Remove control panel, (see "Control Panel" section).
3. Remove mounting screws securing interlock switch to
unit chassis.
4. Disconnect and label wire connections.
NOTE: After repairing the door or the interlock system, it
is necessary to check the switch continuity
before operating the oven.
!
Before replacing a blown monitor fuse, test the primary
interlock switch, secondary interlock switch, monitor
switch, and power relay contacts for proper operation.
If the monitor fuse is blown by a failed switch
operation, all switches and controller must be
replaced.
Primary
Monitor
Secondary
CAUTION
25