Table of Contents
Advertisement
Disassembly Procedures
!
W AR NIN G
Hinges
Door Frame
Latch and Spring
!
A microwave leakage test must be performed anytime
a door assembly is removed, replaced, disassembled,
or adjusted for any reason.
Outer Case
1. Disconnect power to unit.
2. Remove screws securing outer case to the unit.
3. Slide outer case towards the rear of the unit, then up.
4. Place outer case in a safe loacation to prevent
damage.
5. Reassemble in reverse order.
20
Choke
Cover
Inner Door
Assembly
CAUTION
16022923 Rev. 0
To avoid the risk of electrical shock, personal injury or
death; disconnect power to oven and discharge
capacitors before following any disassembly procedure.
Control Panel
The control panel is made up of several components,
such as p.c. board and touch panel.
Control Panel Removal
1. Disconnect power to unit and remove outer case,
see "Outer Case" procedure.
2. Open microwave door.
3. Remove screw securing ground strap to microwave
frame.
4. Remove screws located at the top and along the side
of the touch panel. Remove the screw securing the
gound strap, then open the door. Lift control panel
up and out to release bottom tab connections.
!
CAUTION
Hold ground strap secure when removing or attaching
screw. Place the green wire under the ribbon strap.
5. Place control panel on a flat surface.
6. Reassemble in reverse order.
Screws
©2004 Maytag Services
Advertisement
Table of Contents
