Electonic Model - Quick Refence Guide; Manual Operation - Maytag ALD510D Service Manual

Electronic Model - Quick Reference Guide
PROGRAM DEFROST
2
10
CHECK QTY
PROGRAM 2X
STOP/ START/
RESET
©2006 Maytag Services
Quick Start Reference Guide
Refer to Product Safety Manual for Safety Statements
Oven Clearances
A—Allow at least 2" (5.1 cm) of clearance
around top and sides of oven. Proper air flow
around oven cools electrical components.
With restricted air flow, oven may not operate
properly and life of electrical parts is reduced.
B—Allow at least 2" (5.1 cm) between air
discharge on back of oven and back wall.
So...how do I use it?

Manual Operation

To cook food using a specific entered time and power level:
1. Open oven door and place food in oven. Close door.
2. Press POWER LEVEL pad until desired power level is shown.
3. Press the number pad(s) to enter a cooking time.
4. Press START pad.
5. At end of cooking cycle oven beeps 3 times and shuts off.
1
11
Programming Items
12
This microwave oven has 20 programmable pads (1-20).
NOTE: Only pads 1-10 are preprogrammed at the factory.
3
13
1. Press PROGRAM pad.
• PROGRAM shows in the display.
4
14
2. Press the number pad to be reprogrammed. (ex. pad 5)
• PROG--05 shows in the display.
5
15
• To program pads 11-20, press number pad twice rapidly.
6
(ex. To program pad 15, press pad 5 twice rapidly.)
16
3. Press POWER LEVEL pad to select desired power level.
7
• Power level is displayed. For less than 100%, press
17
POWER pad again until desired power level is shown.
8
18 4. Press the number pad(s) to enter a cooking time.
5. Press START pad to save new programming changes.
9
• STAGE-2 shows in the display and a long beep sounds.
19
6. Repeat steps 3-5 to program in stage two or three.
20
• After touching START pad to save new programming
changes in 2 stage, STAGE-3 shows in the display.
POWER
LEVEL • After touching START pad to save new programming
changes in 3 stage, --END-- shows in the display.
+30 SEC
• Up to three different stages can be programmed.
7. Press STOP/RESET pad to save programming changes.
• Programming function ends.
Complete Owner's Manual available online
16026969 A–3