Control Panel; P.c. Board - Maytag AMV6177AAB Service Manual

Disassembly Procedures
!
W AR NIN G
Baffle
Glass
Door Panel
!
A microwave leakage test must be performed anytime
a door assembly is removed, replaced, disassembled,
or adjusted for any reason.

Control Panel

The control panel is made up of several components,
such as p.c. board and touch panel.
Control Panel Removal
1. Disconnect oven power and remove grille, (see
"Grille" section).
2. Remove screw located at the top of touch panel. Lift
control panel up and out to release bottom tab
connections.
3. Place control panel on a flat surface.
4. Reassemble in reverse order.
©2004 Maytag Services
Door Frame
Assembly
Latch
Spring
CAUTION
To avoid the risk of electrical shock, personal injury or
death; disconnect power to oven and discharge
capacitors before following any disassembly procedure.

P.C. Board

The p.c. board is located at the top on back of the
control panel. Some boards has up to eight connection
plugs which control the following:
CN1
CN2
CN4
Choke
CN5
Cover
FPC (S1)
Relay 8, 10, 11
FPC
Connector
(S1)
Power
Transformer
P.C. Board Removal
1. Disconnect oven power and remove grille, (see
"Grille" procedure).
2. Remove control panel, (see "Control Panel"
procedure).
3. Discharge high voltage capacitor, (see "High Voltage
Capacitor" procedure).
4. Disconnect ribbon connector by sliding top part of
connector upward. Once in released position remove
ribbon from connector by siding ribbon side-to-side.
NOTE: Caution should be used when removing cable
from connector. Ribbon cable has two holes
which connector locks ribbon in place.
5. Disconnect and mark the wire connectors from p.c.
board.
6. Remove screws securing p.c. board to control panel
assembly.
7. Reassemble in reverse order.
NOTE: Do not flex p.c. board.
16023057 Rev. 0
Main power connector
Primary Switch
Humidity Sensor
Damper
Ribbon connector for key panel
Relay connector
(CN5)
(CN2)
(Relay 11)
(Relay 10)
(Relay 8)
(CN1)
(CN4)
23