Example: Prepare A Cup Of Latte Machhiato; Increase Coffee Strength For The Next Beverage - WMF 1000 User Manual

Example: Prepare a cup of latte machhiato

Here is a step-by-step description of how to prepare a cup of latte macchiato.
This description serves as an example for the preparation of all beverages. All steps are carried out for
the preparation of the other beverages according to the example.
>
If necessary, adjust the height of the All-in-One spout to the height of the drinking vessel
The All-in-One spout must not be in the top position.
>
Place an appropriate drinking vessel under the All-in-One spout
>
Press the latte macchiato button briefly
See beverage button overview.
The beverage button lights up when pressed.
The display indicates:
Depending on the setting, the coffee beans are ground appropriately for the selected beverage.
The preparation occurs as specified in the beverage settings.
The beverage is prepared and dispensed into the drinking vessel underneath the spout.
The ready to operate display indicates:

Increase coffee strength for the next beverage

Before each coffee preparation, you can decide how strong you want the next coffee beverage to be.
The following coffee strengths are available:
Mild
• (approximately 15 % weaker than the saved setting)
Normal
• (corresponds to your setting)
• Strong (approximately 15 % weaker than the saved setting)
>
Place an appropriate drinking vessel under the All-in-One spout
>
Select the desired coffee strength with the
>
Select the beverage
The beverage button selected lights up and the beverage name is indicated on the display.
The selected beverage is prepared.
You can cancel the current beverage dispensing. Press the off/c button
1x latte macchiato
your selection pls
08:15 09.06.2008
and buttons
– +
Operation
Adjusting the height
w Operation w WMF All-in-One spout
Page 21
Coffee preparation using the manual insert
w Operation w Prepare coffee beverages
Page 16
w Operation w Prepare milk and milk foam
Page 19
Dispense milk:
The All-in-One spout is at the top position.
Dispense milk foam:
The All-in-One spout is not at the top
position.
If a beverage is selected and the
All-in-One spout is not in the appropriate
position, then a reminder is shown on the
display.
w Operation w Preparing beverages
Page 16
w Bedienen
w Cancel beverage preparation
Page 20
17