Operation - Panasonic KX-TD500 Installation Manual
Digital super hybrid system
Hide thumbs
Also See for KX-TD500:
- System reference manual (1574 pages) ,
- User manual (554 pages) ,
- Features manual (398 pages)
Table of Contents
Advertisement
5.1.3 Operation
PROBLEM
• When using the
speakerphone mode with a
proprietary telephone KX-
T7130 or KX-T7030,
nothing is audible.
• When using the
speakerphone/monitor
mode with a DPT, nothing
is audible.
The unit does not ring.
During a power failure,
extensions assigned for power
failure operation do not
operate.
Originating an outside call,
Call Transfer, or Conference
cannot be performed.
Troubleshooting
PROBABLE CAUSE
• The HANDSET /
HEADSET selector of the
KX-T7130 or KX-T7030
is set to the "HEADSET"
position.
• The "HEADSET" mode
is selected by Station
Programming, "Handset/
Headset Selection."
The Ringer Volume Selector
is set to "OFF."
• A DPT or APT is
connected to the
extension port.
• The dialling mode (tone
or pulse) is improper.
The corresponding CO
button does not exist on the
proprietary telephone.
POSSIBLE SOLUTION
• When the headset is not used, set the
HANDSET / HEADSET selector to
the "HANDSET" position.
• When the headset is not used, select
the "HANDSET" mode by Station
Programming.
Set to "HIGH" or "LOW."
• Disconnect the DPT or APT and
connect a single line telephone.
• Set the Tone / Pulse switch to the
other position.
Programme the CO button. See
"Flexible CO key Assignment" in
Section 4.3 Extension Line of the
Programming Guide.
5.1 Troubleshooting
263
Advertisement
Table of Contents
Troubleshooting
