Stopping The Engine; Remote Control Adjustments - Mercury 200 OptiMax DTS Owner's Manual

To disengage, move one or both control handles until they are more than 5° apart, reduce engine speed below
900 RPM, or increase engine speed beyond 95%.

Stopping The Engine

IMPORTANT: Turning key to the "START" position while the engine is running will result in engine shut down,
while leaving the DTS system active. This will allow the use of the power trim/tilt from the remote control handle.
Reduce engine speed and shift outboard to neutral position. Turn ignition key to "OFF" position.

Remote Control Adjustments

a
a - Detent tension adjustment
b - Control handle friction adjustment screw
1. Remove cover to gain access to screws.
2. Detent tension adjustment - The detent screw can be adjusted to increase or decrease the effort needed to
move the control handle into or out of detent position.
OPERATION
ACTIVE
THROTTLE
ONLY
STATION SELECT
3482
-
+
a
b
5176
45
SYNC
3434
ob00360
-
+
ob01170
b