Mercury 200 OptiMax DTS Owner's Manual page 60

Mercury marine boat owners manual
Hide thumbs Also See for 200 OptiMax DTS:
Table of Contents

Advertisement

2.
Remove spark plug leads to prevent engine from starting.
3.
Straighten the bent tabs on the propeller nut retainer.
4.
Place a block of wood between gearcase and propeller to hold propeller and remove propeller nut.
5.
Pull propeller straight off shaft. If propeller is seized to the shaft and cannot be removed, have the propeller
removed by an authorized dealer.
6.
Coat the propeller shaft with Quicksilver or Mercury Precision Lubricants Anti-Corrosion Grease or 2-4-C with
Teflon.
IMPORTANT: To prevent the propeller hub from corroding and seizing to the propeller shaft, especially in salt
water, always apply a coat of the recommended lubricant to the entire propeller shaft at the recommended
maintenance intervals and also each time the propeller is removed.
7.
Flo-Torq I Drive Hub Propellers - Install forward thrust hub, propeller, continuity washer, rear thrust hub,
propeller nut retainer, and propeller nut onto the shaft.
a -
Propeller nut
b -
Propeller nut retainer
c -
Rear thrust hub
MAINTENANCE
a b
c
d
56
ob00375
ob00376
ob01672
e
f
ob00382
d -
Continuity washer
e -
Propeller
f -
Forward thrust hub

Advertisement

Table of Contents
loading

This manual is also suitable for:

225 optimax dts

Table of Contents