Russell Hobbs RHCM3 Instructions And Warranty page 7


Press PROG button once, the word CLOCK will appear at the top-right corner of
the display.

Press the HR and MIN button continuously to set the present time (See fig. 3(1)).
NOTE: if you keep pressing down HR or MIN button more than two seconds, the
hour or minute number on display will increase rapidly.

Press PROG button once again and the word TIMER shows on the bottom left
corner of the display.

You can set the pre-setting time in the same way by pressing HR button and MIN
button continuously, that is 20:15 (see Fig. 3. Note: the word on display will
disappear automatically and enter normal state if no button is touched for more
than 10 seconds at setting state.

Press ON/OFF button two times, the yellow indicator turn on.

The yellow indicator will go off automatically, at the same time the red indicator
will turn on when the time is 20:15 and the unit will start brewing. NOTE：If no
one there, the appliance will cut off power automatically after two hours.
PRE-HEATING FUNCTION:

To make a cup of good hot Espresso coffee, we recommend you pre-heat the
appliance before making coffee, including the funnel, filter and cup, so that the
coffee flavour cannot be influenced by the cold parts.

Take down water tank cover, add water into the water tank. Then replace the
water tank cover.

Set steel mesh into metal filter (WITHOUT coffee powder ), then place them
upwards into the snap and you can fix them into coffee maker firmly by turning it
anticlockwise until it is at the lock position.(See fig. 4).

Place espresso jug on the removable shelf.

Connect the appliance to the power supply. Make sure the transition knob is on
the OFF position.

Press down /
the internal heat element begins to preheat. After about 3 minutes, the yellow
indicator goes out, you can turn the transition knob to
illuminate again, the coffee will drip down after a few seconds.
button, the yellow and green indicators will both illuminate,
7
now and the yellow will