House And Unit Codes; Programming Magellan's House Code - Magellan Paradox MG-6160 Operation & User’s Manual

Keys 1 to 8: ON state
for X10 outputs 1 to 8
X10 Output 1
X10 Output 2
X10 Output 3
X10 Output 4
X10 Output 5
X10 Output 6
X10 Output 7
X10 Output 8

House and Unit Codes

The Magellan console will be assigned a House Code from A to P while all assigned X10 receivers are assigned a specific address
consisting of the same House Code as the console as well as a unique Unit Code from 1 to 8. This is how Magellan will know which X10
receiver to activate and/or deactivate which will in turn activate and/or deactivate its corresponding device.
3 Magellan - X10 Operation User Guide
Figure 1: Enabling/Disabling the X10 Outputs
Every X10 output is displayed in two screens. Each screen represents an X10 state: ON or OFF.
Use this feature to turn ON or OFF all programmed X10 outputs at the same time.
The checkmark indicates that this particular X10 output state is enabled.
Keys 9 to 16: OFF state
for X10 outputs 1 to 8
The Center keypad can also be used to enable or disable X10 output states.
- Keys 1 to 8 represent the ON states of X10 outputs 1 to 8.
- Keys 9 to 16 represent the OFF states of X10 outputs 1 to 8.
- When a key is illuminated, it means that the output state of the X10 output associated with the illuminated key is enabled.
- If neither key is illuminated, that means that the X10 output will turn neither ON or OFF.
Example: The keypad on the left demonstrates that X10 outputs 1, 5 and 6 are configured to turn ON when the
programmed schedule, action or event occurs. X10 output 2 is configured to turn OFF when the programmed schedule,
action or event occurs. X10 outputs 3, 4, 7 and 8 are disabled and will neither turn ON or OFF.

Programming Magellan's House Code

1. Access the X10 Setup menu (see "Accessing the X10 Setup Menu" on page 2).
2. Press the center [
ACTION
(ok) to program Magellan's House Code.
] key (next) to scroll to the House Code menu. Press the left [ ] key
ACTION