Toshiba FC-22 Manual page 31

Code Description/Mode
390 Automatic removing of devel-
391 oper material
392
Reproduction ratio adjustment of primary scan-
400
ning direction (Fine adjustment of polygonal
motor rotation speed)
401 Reproduction ratio adjustment of secondary
scanning direction (Fine adjustment of transfer
belt motor rotation speed)
402 Fine adjustment of fuser motor rotation speed 3794 0~65535 When the value increases by 1, the
403 Fine adjustment of drum motor rotation speed 1700 0~65535 When the value increases by 1, the
404 Fine adjustment of feed motor rotation speed
406 Feed motor speed adjustment
407 Color registration control forced performing
Correction of fuser motor rotation speed in the
408
thick paper 3 mode
January 2000 © TOSHIBA TEC
Acceptable
Default
Value
All (Y, M, C, K) –
Color (Y, M, C) –
K –
1222 1209~1235 When the value increases by 1, the
1355 1327~1382 When the value increases by 1, the
4289 0~65535 When the value increases by 1, the
–
–
0 0~20
1 - 23
Contents
– The developer material in the de-
– veloper unit is removed into the
– toner bag.
reproduction ratio in the primary
scanning direction (horizontal pa-
per feeding direction) decreases by
approx. 0.082%. (If the values of this
code 400 is changed, the values of
code 05-401, 402, 403, 404 and
474 are optimized.)
reproduction ratio in the secondary
scanning direction (vertical paper
feeding direction) decreases by
approx. 0.074%. (If the values of this
code 401 is changed, the values of
code 05-401, 402, 403, 404 and
474 are optimized.)
rotation speed of fuser motor de-
creases by 0.026%.
rotation speed of the drum motors
(Y,M,C,K) decreases by 0.059%.
rotation speed of the paper feed
motor decreases by 0.023%.
– The paper transport speed of reg-
istration roller in relation to the im-
age printing speed is set at the op-
timum value. (If the value of this
code 406 is performed, the value
of code 05-404 is optimized.)
– Performs the color registration con-
trol.
In this thick paper 3 mode, when
the value is increased by 1, the
fuser motor rotation speed is de-
creased by 0.026%.
FC-22 ADJUSTMENT
Operation
procedure
group
6
6
6
1
1
1
1
1
6
6
1