Cisco ASR 9000 Series Installation Manual page 112

Cisco 40-Gigabit QSFP+ Transceiver Modules Installation
For QSFP+ transceivers equipped with a bail-clasp latch
Step 2
Pivot the bail-clasp down to the horizontal position.
a.
Immediately install the dust plug into the transceivers optical bore.
b.
Grasp the sides of the QSFP+ transceiver and slide it out of the module socket.
c.
For QSFP+ transceivers equipped with a pull tab latch
Step 3
Immediately install the dust plug into the transceiver's optical bore.
a.
Grasp the tab and gently pull to release the transceiver from the socket.
b.
Slide the transceiver out of the socket.
c.
Place the QSFP+ transceiver into an antistatic bag.
Step 4
Figure 2-37
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
2-58
Removing the 40-Gigabit QSFP+ Transceiver Module
Chapter 2 Installing Line Cards in the Cisco ASR 9000 Series Router
(Figure 2-37, top view):
(Figure 2-37, bottom view):