Features
Voltage monitoring:
The voltages 12 V, 5 V and the CMOS battery are monitored.
With hardware monitoring - regardless of the operating system and processor - the advantages
compared to conventional software monitoring are clear:
−
suitable for all operating systems and processor types
−
no additional load on processor (performance)
−
optimum temperature protection, even if process faults or faults are present in the
operating system
−
optimum noise reduction
Three different operating modes are available and can be configured in BIOS Setup - System
Management.
Hard disk connection
An ultra ATA/66 or ultra ATA/100 hard disk must be connected with a cable especially designed for
the ultra ATA/66or ultra ATA/100 mode.
Ê
Connect the end of the cable marked with blue to the system board.
LAN connector
This system board has an optional Intel 82559-EY LAN controller which supports transfer speeds of
10 Mbit/s and 100 Mbit/s. The LAN controller is equipped with a 3 KB transmission and receiving
buffer (FIFO) and supports WOL function through Magic Packetä.
It is also possible to boot a device without its own boot hard disk via LAN. Here Bootix LAN BootP
and Intel PXE are supported.
The LAN RJ45 connector is equipped with a yellow and a green LED (light emitting diode).
1
Green
a connection exists (e. g. to a hub).
Yellow
Link Mode:
WOL mode:
8 - English
2
the LAN connection is active.
TM
a Magic Packet
is being received.
1 = Yellow indicator
2 = Green indicator
A26361-D1239-Z120-2-7419