Internal Ports And Connectors; Hard Disk Connection; Audio Front Panel - Fujitsu Siemens Computers D1858 Technical Manual

Internal ports and connectors

Internal ports and connectors
The positions of the internal ports and connectors are shown on the Cover. Additional information on
some ports is also provided here.

Hard disk connection

If you have connected hard disks to serial ATA (one hard disk is possible per serial ATA
connection), you must configure the respective settings in the BIOS Setup (further information you
can find in the BIOS Setup manual).
An ultra ATA/66 or ultra ATA/100 hard disk must be connected with a cable especially designed for
the ultra ATA/66 or ultra ATA/100 mode.
► Connect the end of the cable marked with blue to the mainboard.
A serial ATA/150 hard disk must be connected with a serial ATA cable.
► Connect the cable to the hard disk and to the connector on the mainboard.

Audio front panel

If you want to use the internal connection for the audio front panel for the front side of the system,
then proceed as follows:
► Remove all plug-in jumpers from the audio front panel connection.
► Connect the cable for the audio front panel.
If you connect audio devices on both the front and the back of the system, you can only
i
use the connections Line out and Microphone once each.
If you have connected audio devices to both Line out connections, only the connection on
the front of the system is active.
If you have connected audio devices to both Microphone connections, only the connection
on the back of the system is active.
10 - English A26361-D1858-Z120-1-7419, Edition 2