Internal Ports And Connectors; Hard Disk Connection - Fujitsu Siemens Computers D1627 Technical Manual

Internal ports and connectors

Selecting settings for 2, 4 or 6-channel audio mode
Depending on the driver for the audio mode and from the operating system used, you can configure
the audio properties, e.g. with Windows 2000 under Start - Settings - Control Panel - Sounds and
Multimedia.
Internal ports and connectors
The positions of the internal ports and connectors are shown on the Cover. Additional information on
some ports is also provided here.
The positions of the internal ports and connectors are shown on the Cover. Additional information on
some ports is also provided here.

Hard disk connection

An ultra ATA/66 or ultra ATA/100 hard disk must be connected with a cable especially designed for
the ultra ATA/66 or ultra ATA/100 mode.
Ê
Connect the end of the cable marked with blue to the mainboard.
A serial ATA/150 hard disk must be connected with a serial ATA cable.
Ê
Connect the cable to the hard disk and to the connector on the mainboard.
If you have connected one or two hard disks to a serial ATA (one hard disk is possible per serial
ATA connection), you must configure the respective settings in the BIOS Setup.
BIOS supports a maximum of four IDE/ATA drives. In some new operating systems two additional
drives can be used, but not as boot drives.
Depending on the settings in BIOS the following configurations are possible:
IDE 1/2 (primary)
2 drives*
2 drives*
Cannot be used
* bootable
If your mainboard supports serial ATA RAID, the following additional option is possible:
IDE 1/2 (primary)
2 drives*
* bootable
10 - English
IDE 3/4 (secondary)
2 drives*
Cannot be used
2 drives*
IDE 3/4 (secondary)
2 drives*
Serial ATA1
Only usable with a
special operating
system
(not bootable)
1 drive*
1 drive*
Serial ATA1
RAID drive*
Serial ATA2
Only usable with a
special operating
system
(not bootable)
1 drive*
1 drive*
Serial ATA2
RAID drives*
A26361-D1627-Z120-1-6319