Panasonic SA-BT100P Service Manual page 62

SA-BT100P / SA-BT100PC
Step 3 Remove 2 screws on Main P.C.B.
Step 4 Detach 25P cable at the connector (CN806) on Main
P.C.B.
Step 5 Detach 14P cable at the connector (CN1101) on Main
P.C.B.
Step 6 Detach Main P.C.B. from the rear panel and position it
according to the diagram show.
Step 7 Attach original cable with extension cable RFKZ0491
(17P cable from CN503 to CN5050).
Step 8 Remove 2 screws from Ac inlet shield plate unit.
Step 9 Remove the AC Inlet shield plate unit.
Step 10 Remove the P.C.B. bracket.
Step 11 Remove 2 screws on D-Amp P.C.B.
Step 12 Remove the wire clamper to detach 3P cable at the
connector (CN5501) on D-Amp P.C.B.
Caution Note: Keep the P.C.B. bracket in safe place. Avoid
denting it. Place it back during assembling.
Step 13 Remove 5 screws at the rear panel.
Step 14 Release the catches and remove the fan unit.
Step 15 Release the tab of the rear panel in the direction of
62