Cleaning The Ink Discharge Passage (Pump Tube Wash); Open The Front Cover - MIMAKI JV33-130 Operation Manual

Cleaning the ink discharge passage (PUMP TUBE WASH)

Perform washing of the ink discharge passage (the pump tube) periodically to prevent ink from clogging due
to the coagulation of ink within the ink discharge passage.
• When the following messages are indicated, check the waste ink tank, and then operate it,
referring to P.4-36 "If Waste ink tank confirming message is displayed" according to the
situation.
Press the
1
mode.
Select [PUMP TUBE WASH] by
2
pressing the
Press the
3
• The carriage moves onto the platen.
• Repeat the idle absorbing operation (Absorbing for 5 seconds and interrupting for 10
seconds) until washing works are completed.

Open the front cover.

4
Press the
5
with the cleaning solution.
• The cleaning solution is applied by drops when
the
• When the
• During the idle absorbing is interrupted, repeat the
drops several times to fill the cap with the cleaning
solution just before the solution overflows from the
cap.
www.uzywane-solwentowe.pl
4-12
C o n f i r m a w a s t e t a n k
C o n t i n u e < > E x c h a n g e
key in the local
keys.
key.
key to fill the cap
is pressed.
is pressed again, drops stop.
C o n f i r m a w a s t e t a n k
E x c h a n g e : e
S T . MA I N T ENANCE
CARR I AGE OU T
S T . MA I N T ENANCE
PUMP T UBE WA SH < e n t >
S T . MA I N T ENANCE
COMP L E T ED
n t
< e n t >
: e n t
Front cover