Cleaning The Ink Discharge Passage [Disway Wash] - MIMAKI JV5-130S Operation Manual

Hide thumbs Also See for JV5-130S:
Table of Contents

Advertisement

CHAPTER 4 Daily Maintenance

Cleaning the ink discharge passage [DISWAY WASH]

Use this function when the [PUMP TUBE WASH] function cannot be used.
There may be a chance that the ink discharge passage can be clogged with coagulated ink. To avoid clogging,
clean the ink discharge passage once a week.
Be sure to wear the supplied goggle and gloves.
The ink contains an organic solvent. If ink settles on your skin, immediately
wash it off with water. If you get ink in your eyes, immediately wash your eyes
with a lot of clean water for at least 15 minutes. In doing so, also wash the back-
side of eyelids to rinse ink away completely. Then, consult a doctor as soon as
possible.
Do not move the carriage out of the capping station by hand. Select the
[ST.MAINTENANCE] function to move the carriage.
First make sure that the pump is not clogged. If the pump is clogged, the clean-
ing function does not work normally. When the [DISWAY WASH] function is exe-
cuted, there may be a case where the cleaning liquid keeps staying in the caps
without flowing out. In such a case, the pump may be clogged. If the pump is
clogged, contact your dealer or a sales office of MIMAKI.
STEPS:
1
Make sure that the printer is in LOCAL mode, and then press the [ST.MAINT] key.
If it is in REMOTE mode, press the [REMOTE] key.
2
Select [DISWAY WASH] by pressing the [ ] key three times and press the [ENTER]
key.
The carriage will come out of the capping station.
Idle suction is performed in cycles of 5-second suction followed by 10-second pause.
If there is a problem with the waste ink tank, the display will show either of the
following messages.
Follow the displayed instructions to restore the normal conditions.
Downloaded From ManualsPrinter.com Manuals
PRE
PRT
AFT
35°C
40°C
50°C
L. ∗ >
[JV5-01]
width : ∗∗∗∗ mm
3
times
ST.MAINTENANCE
DISWAY WASH
No waste ink tank,
or a tank is FULL.
<ENT>keyHIT is after
theTANK set or exchg

Cleaning the ink discharge passage [DISWAY WASH]

ST.MAINTENANCE
CARRIAGE OUT
<ent>
Replace a
<ENT>keyHIT is after
the TANK exchange.
<ent>
waste ink tank.
4-13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jv5-160s

Table of Contents