Basic Operations; Turn On Stb; Power; Channel Up/Channel Down - Xcruiser XDSR4000HD User Manual

BASIC OPERATIONS

8

8.1 Turn on STB

First, press the [Device's Main Power] to
turn on the unit.
When the STB is first used, there will
play the first channel from the default
Channel List. If the STB is not first used,
STB will play the same channel as last
time before turning off.
? Frequently Asked Question
Q: The power of my STB has been turned on
and not in Standby mode, but the TV screen
showed nothing:
A: Make sure the TV set has been set to the
correct video input (not the TV channels). For
example, if you have connected the unit with the
Video1 input of the TV set, the TV set has to be
switched to Video1.
Q: The power of my STB has been turn on
and not in Standby mode, but the TV screen
showed nothing except one box with "No
Signal" image.
A: That means the channel, which you select, is
no signal. It could be several causes:
13
1.
The channel which you select is not in your
allocate satellite. The simply solution is to
change channel.
2.
The signal of current TV channel is too weak.
You can try to change channel to other
strong signal channels. If the problems still
exist, please consult your local dealer or other
professionals for technical service.
3.
You use the Dual LNB, and you need Modify
LNB Type

8.2 Power

Press [Power] Key can enter the Standby
state
In Standby state, press [Power] Key again
can call back the unit and go on play the
previous channel
User can also disconnect the device's
main power to end the Standby state.

8.3 Channel Up/Channel Down

In full screen, press [CH+/CH-] to change
channel.

8.4 Volume Up/Volume Down-

In full screen, press [VOL+/VOL-] to adjust
volume.

8.5 Number

In full screen, use number key and press
[OK] on the Remote Control Unit to
change channel.

8.6 Mute

Press [MUTE] key to mute the sound and
the screen will show up mute OSD.
Press [MUTE] key again to restore sound.

8.7 Pause

In playing mode, press [Pause] key, the
picture will be paused, but the sound of
the channel will still continues.
Press [PLAY] key again, the screen's
picture will skip over to the current
playing picture, and the sound of the
channel will corresponding playing.

8.8 Recall

Press [RETURN] key will directly switch
to the previous channel that you played
before current channel.