Connecting The Network - Xcruiser XDSR4000HD User Manual

This allows multiple antennas to be
connected to the receiver at the same
time.
If you have two or more fixed antennas
or LNBs, then we recommend you use a
DiSEqC 1.0 switch.
Connect the coaxial cable from the
first LNB to the LNB 1 or LNB A input
connector of the DiSEqC switch.
Do the same for any other LNBs that you
have.
Connect one end of a coaxial cable to
the RF output connector of the DiSEqC
switch, connect the other end to the LNB
IN socket on the receiver.
To the digital receiver, you can connect
either a single satellite antenna directly
or LNB of multi-feed equipment.
12

7.2 Connecting the Network

1. CONNECTING TO THE LAN:
Connect one end of the Ethernet cable to
the product and the other end to the LAN
router.
2. CONNECTING TO THE WI-FI (WIRELESS LAN):
You can connect the network via the
Wi-Fi access point or DSL/cable modem.
Plug in the wireless USB dongle to the
USB port.(Separate purchase required)
Set the options for the Wi-Fi.
NETWORK NAME (SSID): Select the network
name of your Wi-Fi access point from the
list.
SECURITY TYPE (WEP): This product supports
WEP 40/128bit ASCII and WEP 40/128bit
HEX. The security type of the Wi-Fi and
the product shall be set the same.
PASSWORD: When using the security type,
you must set the password. Enter the
same password in the Wi-Fi setting menu.
3. CONNECTING TO THE 3G:
Connect the network via the 3G dongle.
Plug in the USB that has 3G dongle.
Note
Make sure the distance between the Wi-Fi access
point and the product is not too far away. This may
lower the quality of service.
It is recommended to purchase a wireless USB
dongle distributed by RT5370. Other products may
not function or respond.
It is recommended to purchase a 3G USB dongle
distributed by huawei E1750 , E1550 , E1752 ,
E173 Other products may not function or respond.
We recommend the network connection over a
direct LAN.