NightWatcher NW700 User Manual page 5

Installing your Nightwatcher NW700 on surface. (see fig. 4 & fig. 5)
1. Place plastic masonry plugs into desired surface aligning holes as shown below. Using a screwdriver,
fasten mounting plate directly to surface using screws E.
2. Feed the cable through the back mounting box and bush the cable entry to avoid abrasion to the cable.
3. Wire the unit as follows: (Ensure all wires are connected securely and that no loose strands are exposed)
4. Make sure the polarity is correct. Double check the connections after wiring. Errors may damage the
motion sensor or cause a fire hazard.
5. Using a screwdriver, fasten the unit to the mounting plate using the supplied screws.
Fig. 4
Fig. 4
Fig. 4
Fig. 5
5