Download Print this page

NightWatcher NW200 User Manual

Nw200 nightwatcher

Download this manual

Table of Contents

Page 2: Installing The Bulb
NIGHTWATCHER NW200 USER MANUAL Read all instructions before proceeding with the installation OVERVIEW OF NIGHTWATCHER NW200 Push-button 3 motion sensors INSTALLING THE BULB Unscrew the lamp cover of the luminaire and install a 150W J-type lamp or equivalent energy saving lamp. Note don’t touch filament with bare hands.
Page 3: Installation And Wiring Instructions
MOUNTING THE FITTING To ensure correct operation of the sensor, mount the luminaire that traffic passes across the detector. TOP VIEW GOOD SENSITIVITY LESS SENSITIVITY INSTALLATION AND WIRING INSTRUCTIONS Remove the inset back mounting box from the luminaire. Fit the inset back mounting box onto the wall and tighten the screws at a height that ensures adequate coverage of the area by the infrared detector.
Page 4 FUNCTION This light is equipped with 3 motion sensors: zone 1 covers 60 degree, zone 2 covers 100 degrees and zone 3 covers 60 degrees. 220 degrees (maximum) in total for 3 zones. ZONE 2 ZONE 1 ZONE 3 TOTAL DETECTION RANGE When Power is first turned on the light will go to self calibration mode for about 1 minute.
Page 5: Operation
AC 220-240V 50Hz Time adjustment: Fixed at 3 minutes approx. Load rating: J-Type 150 Watts Max, or equivalent energy saving lamp Tested to: The relevant AS/NZS standards IP rated: IP55 Imported and Distributed by: Hamer Ltd Ph. 0800 239 239 www.nightwatcher.co.nz...