NightWatcher NW700 User Manual page 4

Unscrew the waterproofed cover using the provided Allen key, then insert the Micro SD card
until it automatically locks into place.
When LED light turns green, meaning Micro SD card is being read, do not remove SD card or
data may be lost.
To remove Micro SD card, push in Micro SD card to eject then pull out.
Step 2. Installing the Nightwatcher:
IMPORTANT
IF IN ANY DOUBT ABOUT THE INSTALLATION OF THIS PRODUCT, CONSULT A QUALIFIED ELECTRICIAN
- This product must be earthed
- Do not mount the unit against flammable surfaces
- The motion detector will not operate correctly if it is installed:
1 Near the outlet of a central heating boiler
2 Near air conditioning unit
3 Pointing directly at moving vehicles
4 Within sight of reflections from moving water
5 Where other lamps could shine on the detector
* DO NOT REMOVE THE TAPE UNTIL YOU FINISH THE INSTALLATION. IF THE TAPE COMES OFF THE LIGHT DURING THE
INSTALLATION, PLEASE REPLACE IT OR HOLD THE LIGHT HEAD TO AVOID SWIVELING AND DAMAGE TO THE PRODUCT.
* BEFORE ATTEMPTING ANY INSTALLATION OR MAINTENANCE, ENSURE THAT THE ELECTRICAL SUPPLY IS SWITCHED OFF AND
THE CIRCUIT FUSES REMOVED OR THE OFF/REC BUTTON IS IN THE OFF POSITION.
* PLEASE MAKE SURE THE VOLTAGE AND POLARITY ARE CORRECT BEFORE CONNECTION. INCORRECT VOLTAGE MAY CAUSE
ELECTRIC SHOCK. IF YOU ARE NOT SURE, PLEASE CONTACT A QUALIFIED ELECRTCIAN.
* NOTE; IT IS RECOMMENDED YOU MOUNT THE NIGHTWATCHER NW700 1.8-2.1M ABOVE THE GROUND FOR OPTIMUM
PERFORMANCE, DO NOT MOUNT THE FIXTURE BELOW 1.2M. SEE BELOW FIGURE FOR DETAILS OF PERFORMANCE RANGE.
Detection range: 10M x 210° (see fig. 3)
LED light
GOOD SENSITIVITY
Micro SD card slot
Fig. 4
TOP VEW
LESS SENSITIVITY
Fig. 2
4
Fig. 1
Fig. 3