Toilet; Waste Water System - Waste Pump - Winnebago ERA User Manual

Era motorhomes
Hide thumbs Also See for ERA:
Table of Contents

Advertisement

TOILET

The toilet in your motor home is very similar
to the household type, except that it is designed to
use only a small amount of water per flush. It
uses a high velocity jet of water, producing a
swirl effect, to efficiently cleanse the bowl.
Important "Don'ts"
Don't use facial tissue or regular toilet tissue in
the RV toilet. These will not disintegrate
sufficiently and will often cling to the sides of
the holding tank. Toilet tissue made
specifically for use in RV toilets and holding
tanks is available at most RV supply centers.
Don't dispose of sanitary napkins or other
non-dissolving items in the toilet.
Don't put automotive antifreeze or caustic
chemicals, such as laundry bleach or heavy
detergents into the toilet or holding tank.
These products may damage plastic or rubber
parts in the system.
See winterizing instructions at the end of this
section to prepare the toilet for storage in freezing
conditions.
Further Information
See the toilet manufacturer's operation
information in your InfoCase for complete
operating, care, and maintenance information.
WASTE WATER SYSTEM -
WASTE PUMP
(Holding Tanks)
The drainage system is self-contained and
uses two separate holding tanks to contain the
waste water until it can be dumped at an
appropriate waste water disposal site. This means
you can use the toilet, sinks, and shower even in
areas where utility hookups are not available.
The black water holding tank contains the
sewage from the toilet and may include bathroom
lavatory on some models. The gray water holding
tank contains the waste water from the galley
sink and shower, and may include bathroom
lavatory.
See "Specifications" in Section 1 -
Introduction for tank capacities for your model.
Waste Pump
The 12-volt Waste Pump disposes holding
tank waste through a small diameter sewer hose.
Waste Pump
(Located beneath coach)
-Typical View
NOTE: If Waste Pump stalls, check breaker in
the load center. If problem persists,
remove end cap and manually turn pump
shaft (located on the end of the Waste
Pump) with a screwdriver.
Further Information
For further Waste Pump operating and
troubleshooting information, see the
manufacturer's user guide provided in your
InfoCase.
SECTION 7 –
PLUMBING
7-7

Advertisement

Table of Contents
loading

Table of Contents