Ford 1998 Windstar Owner's Manual page 259

Lug nut tightening sequence
The lug nuts should be tightened to 83-113 ft-lb (113-153 Nm).
Replace the wheel cover by pressing it into place. If you
13.
have the standard wheel covers, you must align the notch in
the wheel cover with the tire's valve stem and align the
recess in the back of the wheel cover with one of the lug
nuts. If you have the optional aluminum wheel, press the
center wheel cap into place after matching up the design of
the wheel cap to the wheel.
Replace the jack in the storage compartment and make sure
14.
the jack is securely fastened.
Store the flat tire under the vehicle just as you would store
15.
the spare tire. Refer to the section on Stowing the Spare Tire
in this chapter.
Unblock the wheels.
16.
Retighten the lug nuts to the specified torque at 500 miles
(800 km) of operation, after any wheel change, or any time the
lug nuts are loosened.
260