Table of Contents
Advertisement
DISPLAY INDICATORS
The radio's display is shown below. The character line is used to display
system or area and group or channel names and also operational messages to
the user. The line contains eight Dot Matrix LED characters. The 7 status
indicators are used to show the various operating conditions of the radio.
TX
BSY
SCN
S
P1
P2
PVT
In EDACS operation the P1 & P2 indicators can be programmed to flash
when the radio has received an individual call. Display shows "C* to
show receipt of I-CALL.
DISPLAY ALPHA INDICATORS
The radio is capable of displaying status indicators in the alpha display.
Some of these messages will use the entire display while others use only two
or three characters. When the short message is displayed it may be on the right
14
Figure 3 - Sample MDX Display
On indicates the radio is transmitting.
Lights when a group is active (trunked system) or
when a channel is busy (conventional system).
Flashes when a call is queued on a trunked system.
ON indicates scan is enabled.
ON indicates group/channel in scan list.
ON indicates selected channel is a priority channel
(conventional only).
ON indicates selected channel is a priority 2 chan-
nel (conventional only).
ON indicates selected channel has been pre-pro-
grammed for Aegis operation. Flashes indicates
receiving an encrypted digital voice call.
NOTE
Advertisement
Table of Contents
