Table of Contents
Advertisement
In rare instances, several low pitched, fast "chirps" will be heard before
the Call Originate tone sounds. This is caused by your radio
automatically re-trying to gain access to the system after the first
attempt failed (Auto-Retry). This normally occurs in fringe areas and
in heavily used systems. The Auto-Retry is one of the features utilized
by the radio system to provide reliable communications under adverse
conditions.
MANUALLY ENTERING A GROUP ID (System Model Only)
1.
Press the A2 button and observe "GID ENTR" in the display
2.
Enter the group ID number using the numeric keypad. (Valid range
1-2047).
3.
Press the A2 button again and observe "GID nnnn" (where nnnn is
the entered number) in the display. This new group will replace the
first group in the list.
It is recommended that a null group be programmed into the first
location initially. This will avoid overwriting a desired group from the
list unintentionally.
RECEIVING AN EMERGENCY MESSAGE
From The Selected Group
When an emergency is received from a member of your selected group,
"EMERGNCY" flashes on your display.
If an emergency call is made, "E*xxxxxx" (where xxxxxx is the balance
of the group display) will flash in the display until the call is complete.
When an emergency transmission is received from a member of your
selected Group or System; the "E*" portion of the display will flash, the BSY
indicator will come on, and a tone sounds. When this occurs, follow your
standard emergency procedures. The emergency display remains on until the
emergency is cleared.
NOTE
NOTE
25
Advertisement
Table of Contents
