LBI-39015 LBI-39015 Continued Continued SPECIFICATIONS* STANDARD METHODS PROCEDURES RECEIVER Mechanical Shock 516.2/Proc 1 516.3/Proc 1-6 516.4/Proc 1-6 Frequency Range Humidity 507.1 507.2 507.3 Low Split Radio 136.0 to 153.0 MHz High Split Radio 150.0 to 174.0 MHz Salt Fog 509.1/Proc 1 509.2/Proc 1 509.3/Proc 1 ±...
Display Board for the alphanumeric LED dis- play. The synthesizer circuit generates all transmit and receive The Ericsson GE VHF MDX™ Mobile Radio is a synthe- Carrier Control Timer (CCT) RF frequencies. The synthesizer frequency is controlled by the sized, wide band radio that uses integrated circuits and micro- microprocessor located on the Audio/Logic Board.
LBI-39015 LBI-39015 In the conventional mode of operation, the user selects a Table 2 - Digital Channel Guard Codes CABLE OPTION PMCD7ZE channel and communicates on that channel in the conventional Cable Option PMCD7Z (19D851585P14) is used to bring mode. A system refers to a set of channels and a channel is a all option connections from the system Board through the back PRIM.
Page 6
LBI-39015 LBI-39015 Scan operation will be determined by the following condi- Press the programmed flex key, mapped to scan DELETE SCAN CHANNEL (S, P1, P2) DISPLAY tions: add/delete, to add the channel to the scan list. The S indicator will be shown in the display to indicate that Confirm that the radio is on.
Page 7
LBI-39015 LBI-39015 grammable from 0.3 to 5 seconds on 0.1 seconds MONITOR (CLR) SWITCH OPERATION IN steps. If no other channel activity occurs during this SCAN time, scanning will then resume. The priority chan- nels are still being sampled during the hang time. The CLR switch does not operate while scanning inac- tive channels.
LBI-39015 LBI-39015 Priority 1 Channel Programming: scan sequence. If the number of non-priority channels is less Carrier on P2 detected/wrong Channel Guard CONDITION 3: P2 has Channel Guard, P1 does not than or equal to four, then all non-priority channels will be P1-P2-P1-P1-P1-P1-P1-P1-P1-P1-P1-P2-P1...
During that time subsequent pressing of the flex key or Group/SEL buttons will toggle the T99 state between 652.5 Hz Tone D is the diagonal tone used (Ericsson GE tone sys- OFF and ON. 607.5 Hz In the Ericsson GE tone format, the first tone may be tems only) when the first and second tone frequencies are the 787.5 Hz...
Page 10
LBI-39015 LBI-39015 In the Motorola tone format, the first tone may be one to Table 5 - Motorola Type Code Numbers Table 6 - Motorola Tone Frequencies and Groups three tones: A for individual call, B for Quick-Call and C for Group Call.