Table of Contents
Advertisement
CONTROLS (CONT'D)
SYS
CHANNEL/SEL
CLR
HOME/
EMERGENCY
FLEX KEYS
A1, A2
DISPLAY INDICATORS
The radio's display is shown in Figure 2. The character line is used to
display system or area and group or channel names and also operational
messages to the user. The line contains eight Dot Matrix LED characters. The
7 status indicators are used to show the various operating conditions of the
radio.
10
Momentary switch. The SYS (SYSTEM) button is
used to select system changes. System may be
incremented by pressing and releasing the SYS
button. Alternately, when the display shows the
System name, the CHANNEL/SEL buttons may be
used to increment or decrement the system selec-
tions. (NOTE: The radio may be programmed with
wrap around on the system selection; this would
allow the radio to switch from the highest to lowest
system with one change instead of ramping all the
way through the list.)
Ramp Switch. The CHANNEL/SEL button is
used to increment or decrement the current channel
selection. It is also used as described above to
increment/decrement the System. In conventional
mode, these buttons change the channel selection.
Momentary switch. The CLR button is used to exit
from the menu operation, monitor a conventional
channel or end a special/individual call.
Momentary switch. The HOME or EMER-
GENCY button is used to select a home system,
or channel. The radio may be programmed to revert
to a particular system or channel within the se-
lected or home system. It may also be programmed
to send an emergency message (GESTAR) when
pressed and held for approximately one second
(either on the selected system or on the Home
system).
The auxiliary buttons are used to access frequently
used menu selections quickly. They can also be
programmed as a HOME, External Alarm, Public
Address, T99 decode, and Scan add/delete.
Advertisement
Table of Contents
