Table of Contents
Advertisement
3.
Press the CLR button to return the radio to normal operation.
1.
Press the A1 or A2 button (pre-programmed). "STATUS" appears in
the display. Use the GROUP/SEL button to view/select the status
to be sent.
2.
Press the PTT switch to send the status to the site or to be stored in
the radio memory where it can be polled by the site at a future time.
3.
Press the A1 or A2 button to return to normal operation.
MESSAGE OPERATION
Message operation permits the transmission of pre-programmed mes-
sage(s) to the EDACS site. The message can be sent in two ways.
1.
Press the MNU button until "MESSAGE" appears in the display. Use
the GROUP/SEL buttons to step through the selections.
2.
When the desired message is displayed, press the PTT switch to send
the message to the site. If the site does not receive the message
properly, the radio will sound a low pitched tone.
3.
Press the CLR button to return the radio to normal operation.
1.
Press the A1 or A2 button (pre-programmed). "MESSAGE" appears
in the display. Use the GROUP/SEL button to view/select the
message to be sent.
2.
Press the PTT switch to send the message to the site. If the site does
not receive the status properly, the radio will sound a low pitched tone.
3.
Press the A1 or A2 button to return to normal operation.
DYNAMIC REGROUP OPERATION
Dynamic regroup operation permits multiple talk groups (up to eight) to
be added to a radio via the system manager. The radio must be pre-pro-
grammed to respond to regrouping. Dynamic regrouping will not be activated
in a radio until an activation message is sent by the system manager. Each
radio that receives and acknowledges the regrouping instructions is success-
fully regrouped.
OR
OR
33
Advertisement
Table of Contents
