Recommended Computer Configuration; Installation Of The Laserpro Usb Driver - GCC Technologies LaserPro SmartCut X380 Series User Manual

Other software such as EngraveLab and PhotoGrav may work with the LaserPro
SmartCut X380, but these are not supported. Any software that can output to the
LaserPro Print Driver should work.
Support will not be offered, if you experience output problems with non-supported
graphics software.

4.2.1 Recommended Computer Configuration

The LaserPro SmartCut X380 operates under Windows operating systems and is designed to
work on a computer that meets the following minimum requirements.
Computer
•
CPU
•
RAM
•
FDD
•
HDD
•
SVGA
•
On Board Parallel Mode (Enabled from your motherboard's BIOS):
•
SPP – Preferred Mode
•
ECP – Cable (Less than 1.8 meters)
Software
•
The LaserPro SmartCut X380 drivers are designed for Windows 2000, XP, or newer
operating systems.

4.2.2 Installation of the LaserPro USB Driver

This section is only required for users that use USB connectivity. If you use the Parallel
Printer Port connectivity, then you can skip this section.
•
•
•
Distributed & Supported by: Jorlink USA, Inc. | Tel: (336) 288-1613 | sales@jorlink.com | www.JORLINK.com
NOTE
Pentium 90 (or equivalent) or greater
32MB or higher
One 3.5" 1.44 MB Floppy Disk Drive
1.2 GB Hard Drive or greater
15" Super VGA Monitor
NOTE
Do NOT connect the USB cable to the PC before you have completed both the
LaserPro USB driver and LaserPro print driver installation.
Install the LaserPro USB driver BEFORE installing the LaserPro SmartCut X380
print driver.
This set of USB drivers are not the same as the native USB drivers for Microsoft
Windows.
1) Turn on your computer and insert the LaserPro CD.
2) From the auto run menu, select X380
Driver installation.
3) The LaserPro USB Driver installation program will update your Windows USB
driver. When the notification pops up, select Yes to continue the installation.
4) Click Start to the installation.
USB Driver to start the LaserPro USB
- 23 -
SmartCut X380 User Manual