Power-Up Screen; Operating Screen; Beltpack Activity Code Definitions - Telex RadioCom BTR-700 Operating Instructions Manual

Power-Up Screen

•
This screen is displayed only on power-up, first use de-
fault, and factory default.
•
st
The 1 upper right corner number displays the base's soft-
ware revision. The version number increments for
changes in operational software.
•
nd
The 2 upper right corner number displays the base's
channel map (frequency plan) version. The version num-
ber increments for changes in the channel map.
•
Once the power-up screen is displayed, it will change to
the operating screen after a few seconds.

Operating Screen

•
Screen is displayed after power-up screen.
•
System will revert to this screen if no activity is detected
on the LCD display buttons after 3 minutes.
•
Screen displays current status of the system.

Beltpack Activity Code Definitions:

no tx = No Beltpack Transmit Carrier Detected
Off = Receiver is not selected on front panel
Tx = Beltpack is on
Power-Up Screen
Telex
RadioCom
Operating Screen
Group 03A
T1
Tx
On
6-5
S B20001
C60001
TM
no tx
R1
2 Off
3
Tx
4
Tx