Draytek Vigor2860 Series User Manual page 75

DNS Server IP Address
After finishing all the settings here, please click OK to activate them.
D e t a i l s P a g e f o r P
D e t a i l s P a g e f o r P
To use PPTP/L2TP as the accessing protocol of the internet, please click the PPTP/L2TP tab.
The following web page will be shown.
Available settings are explained as follows:
Item
PPTP/L2TP
Gateway IP Address – Type in gateway IP
address.
Default MAC Address – Type in MAC address for the
router. You can use Default MAC Address or specify
another MAC address for your necessity.
Specify a MAC Address – Type in the MAC address for
the router manually.
Type in the primary IP address for the router. If necessary,
type in secondary IP address for necessity in the future.
P T P / L 2 T P i n W A N
P T P / L 2 T P i n W A N
Description
Enable PPTP- Click this radio button to enable a PPTP
client to establish a tunnel to a DSL modem on the WAN
interface.
Enable L2TP - Click this radio button to enable a L2TP
client to establish a tunnel to a DSL modem on the WAN
interface.
Disable – Click this radio button to close the connection
through PPTP or L2TP.
Server Address - Specify the IP address of the PPTP/L2TP
server if you enable PPTP/L2TP client mode.
Specify Gateway IP Address – Specify the gateway IP
65
1 ( P h y s i c a l M o d e :
1 ( P h y s i c a l M o d e :
V D S L 2 )
V D S L 2 )
Vigor2860 Series User's Guide