Lennox XP14 Elite Series Installation Instructions Manual page 6

MAINTAIN MINIMUM PANEL ANGLE (AS C LOSE TO PARALLEL WITH THE UNIT
AS POSSIBLE) WHILE INSTALLING PANEL.
HOLD DOOR FIRMLY TO THE HINGED
ANGLE MAY BE TOO SIDE TO MAINTAIN
EXTREME --_ FULLY_ENGAGED TABS
PREFERRED ANGLE
FOR INSTALLATION
Detail D
Figure 9. Removing/Installing Louvered Panels
(Detail D)
CAUTION
In the U,S.A.. wiring must conform with current local codes
and the current National Electric Code (NEC). In Canada,
wiring must conform with current local codes and the current
Canadian Electrical Code (CEC),
Refer to the furnace or blower coil installation instructions
for additional wiring application diagrams and refer to unit
nameplate for minimum circuit ampacity and maximum
overcurrent protection size,
1. Install line voltage power supply to unit from a properly
sized unit disconnect switch,
2. Ground the unit at the unit disconnect switch or to
earth ground.
3. To facilitate conduit, a hole is provided in the bottom of
the control box, Connect conduit to the control box
using a proper conduit fitting,
4. Units are approved for use only with copper
conductors. (A complete unit wiring diagram is
located inside the unit control box cover.)
LINE VOLTAGE
FIELD INSTALLED
WARNING! - ELECTRIC SHOCK HAZARD. Can cause INJU-
RY or DEATH, Unit must be grounded in accordance with
national and local codes.
Z,/iXX NOTE - For use with copper conductors only. Refer to unit
rating plate for minimum circuit ampacity and maximum over-
current protection size.
Figure 10. Outdoor Unit Typical Field Wiring
NOTE - For proper voltages, select thermostat wire
gauge per the following chart:
Table 2. Wire Run Lengths
Wire run length AWG # Insulation type
color-coded, temperature
rating 35°C minimum
less than 100' (30m) 18
more than 100' (30m) 16
5. Install room thermostat (ordered separately) on an
inside wall approximately in the center of the
conditioned area and 5 feet (1.5 m) from the floor. It
should not be installed on an outside wall or where it
can be affected by sunlight, drafts or vibrations,
6. Install low voltage wiring from outdoor to indoor unit
and from thermostat to indoor unit, See figures 11 and
12 on page 7,
NOTE - 24V, Class II circuit connections are made in the
low voltage junction box,)
,WARNING
Page 6
505244M 04/08