Download Print this page

Lennox XP14 Elite Series Installation Instructions Manual page 5

Xp14 elite series heat pumps
Hide thumbs Also See for XP14 Elite Series:

Advertisement

With unit positioned at installation site, remove two side
Iouvered panels to expose the unit base pan. Install the
brackets as illustrated
in figure 6 using conventional
)ractices; replace the panels after installation is complete,
#101/2"
LONG
SELF-DRILLING
SHEET
METAL SCREWS
COIL
STABILIZING
BRACKET
(18 GAUGE METAL - 2"
WIDTH;
HEIGHT AS
REQ'D)
#101-1/4"
LONG HEX
HD SCREW
&
FLATWASHER
BASE PAN
PLASTIC ANCHOR
- USE IF CONCRETE
(HOLE DRILL 1/4"); NOT IF PLASTIC
SLAB
(HOLE DRILL 1/8").
l
Deck Top
_J _
Mounting
__
STABILIZING
MINIMUM
1
PER S'DE \2
L
'I _:_ 'l'
ANGLE
ONE BRACKET
PER SIDE (MIN.); FOR EXTRA STABILITY,
2 BRACKETS
PER SIDE, 2" FROM EACH CORNER.
Figure 6. Installing
Stabilizer
Brackets
(Slab Side Mounting)
ROOF MOUNTING
Install unit 6" (152 mm) above the roof surface to avoid ice
build-up around the unit. Locate the unit above a load
bearing wall or area of the roof that can adequately support
the unit, Consult local codes for rooftop applications.
If unit cannot be located away from prevailing winter winds,
construct a wind barrier sized at least the same height and
width as outdoor unit, Position barrier 24" (610 mm) from
the sides of the unit in direction of prevailing winds as
illustrated in figure 7,
prevailing winter winds
r
wind barrier
I
24"
inlet air ,_
_641'0 mm)
inlet al_
4_
inlet air
O
inlet air
Figure 7. Rooftop Application with Wind Barrier
Remove the Iouvered panels as follows:
1, Remove two screws, allowing the panel to swing open
slightly as illustrated in figure 8,
2. Hold the panel firmly throughout this procedure.
Rotate bottom corner of panel away from hinge corner
post until lower three tabs clear the slots as illustrated
figure 8, Detail B.
3, Move panel down until lip of upper tab clears the top
slot in corner post as illustrated in figure 8, Detail A.
Position and Install
Panel--Position
the panel almost
parallel with the unit as illustrated in figure 9, Detail D on
page 6 with the screw side as close to the unit as possible,
Then, in a continuous motion:
slightly rotate and guide the lip of top tab inward as
illustrated in figure 8, Details A and C; then upward into
the top slot of the hinge corner post,
rotate panel to vertical to fully engage all tabs,
holding the panel's hinged side firmly in place, close
the right-hand side of the panel, aligning the screw
holes,
When panel is correctly positioned and aligned, insert the
screws and tighten,
IMPORTANT! Do not allow panels to hang on unit by top tab. Tab
is for alignment
and not designed
to support weight of panel.
Panel shown slightly rotated to allow top tab to exit (or enter) top
slot for removing (or installing) panel.
SCREW
{OLES
LIP
Detail
A
Detail
B
iiiiiii+
ROTATE IN THIS DIRECTION;
THEN DOWN TO REMOVE
PANEL
Figure 8. Removing/Installing
Louvered Panels
(Details A, B and C)
Page 5
XP14 SERIES

Advertisement

loading