Service Manual – SW900
Right Side Broom Control Cable Removal/Installation
Note:
This procedure refers to the
right side reduction unit; the
procedure for the left side
reduction unit is the same.
Disassembly
1
Drive the machine on a level floor and ensure
that it cannot move
2
Turn the ignition key to "0"
3
Remove the hopper by using its transport handle
and wheels
4
Disengage the front fastener and open the
battery/engine compartment hood.
5
Remove the screws (A) and the side panel (B)
6
(Right side) Remove the nuts (C) and the right
cover (D)
(Left side) Lift the tab (E) and turn the knob (F)
counter-clockwise until it is disengaged, then
open the left door (G)
7
Remove the screws (H) and the nut (I), then
remove the side broom reduction unit guard (J)
Side Broom System
126
P200350