CHAPTER 2 SCANNING
Introduction
This chapter provides instructions for how to scan bar codes and send the data to a host. Beeper and LED
definitions are also included.
Scanning
See
Chapter 1, Getting Started
Aim the scanner at the bar code.
1.
Press the scan (+) button.
2.
Scanning
Figure 2-1
Ensure the aiming dot is centered on the bar code.
3.
The scanner beeps and the LED turns green to indicate a successful decode. See
beeper and LED definitions.
NOTE The scanner cannot scan bar codes when it is connected to the host via the USB host cable.
to install and program the scanner. To scan:
Table 2-1
and
Table 2-2
for