Fuel Tank Cap; Engine Cover Latch - Sea-doo 2005 3D RFI Operator's Manual

2005 3d rfi
Table of Contents

Advertisement

1. Steering pole
Steering pole weight is reduced at the
handlebar by the action of a return
spring. You may want to change the
weight feeling at the handlebar, there
is an adjustment for that purpose. If
you install or remove the "moto" seat,
you may want to readjust the spring
tension.
1. Return spring
2. Adjustment
3. To reduce weight at handlebar
4. To add weight at handlebar
Ensure to adjust handlebar to the de-
sired position before use. Refer to
HANDLEBAR ADJUSTER.

8) Fuel Tank Cap

Unscrew the cap counterclockwise.
After fueling, reinstall cap and fully
tighten.
______________________
34
Always stop the engine before re-
fueling. Fuel is flammable and ex-
plosive under certain conditions.
Always work in a well ventilated
area. Do not smoke or allow open
flames or sparks in the vicinity. Fu-
el tank may be pressurized, turn
cap slowly when opening. Never
use an open flame to check fuel
level. When fueling, keep water-
craft level. Do not overfill or top
off the fuel tank and leave water-
craft in the sun. As temperature
increases, fuel expands and might
overflow. Always wipe off any fuel
spillage from the watercraft. Peri-
odically verify fuel system.

9) Engine Cover Latch

CAUTION:
er should be done only when the
watercraft is out of the water. Re-
moving engine cover while on wa-
ter might allow water to enter and
to fill the bilge. If you need to reach
the storage area or the fire extin-
guisher while on water, first turn off
engine. Ensure to be on calm water
and adopt a stable stance. Partial-
ly open engine cover just enough to
reach the storage area. Close and
relatch engine cover as quickly as
possible.
Removing the engine cover gives ac-
cess to the fire extinguisher storage
area, storage tray, tool kit and the en-
gine compartment.
First, stop the engine then raise and
stabilize the steering pole at its highest
position.
Pull the latch lever upward to unlock
the engine cover.
Lift up the rear portion of engine cover,
and pull rearward to remove.
www.SeaDooManuals.net
WARNING
Removing engine cov-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents