Erase Function - JVC CA-WMD90R Instructions Manual

6
Rotate the right jog dial to select the track you want
to move.
Ex.: When you want to move track 5
7
Press SET.
• If you have selected a wrong track number, press
CANCEL, then select the correct track number again.
8
Rotate the right jog dial to select the position where
you want to move the track.
Ex.: When you want to move to the track 3 position
9
Press SET.
• If you have selected wrong tracks, press CANCEL,
then select the correct tracks by repeating from step
6.
10
Press ENTER (START) to finish the editing
procedure.
11
Press 0 for MD deck B to eject the MD.
"WRITING" appears while the editing you have
made is being recorded on the MD.

ERASE Function

This function allows you to erase an unwanted track.
• To stop any time during editing process, press MD EDIT.
On the unit ONLY:
1
Insert an MD you want to edit into the MD B
loading slot.
2
Press one of the MD number buttons (MD 1, MD 2,
and MD 3) corresponding to the MD you want to
edit.
MD deck B starts playing the MD.
3
Press MD EDIT.
MD deck B enters editing mode (with DIVIDE
function selected).
4
Rotate the right jog dial until "ERASE ?" appears.
5
Press SET.
6
Rotate the right jog dial to select the track you want
to erase.
Ex.: When you want to erase track 4
7
Press SET.
• If you have selected a wrong track number, press
CANCEL, then select the correct track number.
8
Press ENTER (START) to finish the editing
procedure.
9
Press 0 for MD deck B to eject the MD.
"WRITING" appears while the editing you have made
is being recorded on the MD.
– 42 –
Continued