Assigning A Title Using The Remote Control - JVC CA-WMD90R Instructions Manual

Assigning a Title Using the Remote Control

In the following example, the process is explained from the
very first — that is, inserting a disc. If you already start
recording or playing, start from step 3.
• To stop any time during the following process, press MD
TITLE INPUT.
1
Insert an MD you want to edit into the MD B
loading slot.
2
Press one of the MD number buttons (MD 1, MD 2,
and MD 3) corresponding to the MD you want to
assign titles.
MD deck B starts playing the MD.
• If you do not have to listen to the MD while
assigning titles, press 7 for MD deck B to stop
playing.
3
Press MD TITLE INPUT.
MD deck B enters title entry mode.
• Track title entry indication (mode): appears when
you press MD TITLE INPUT while playing or
recording.
• Disc title entry indication (mode): appears when
you press MD TITLE INPUT when MD deck B
stops.
4
Press ø or Ø to change the title entry mode.
• Title entry mode changes as follows:
1st track
Disc
title
title
Last track
title
5
Press SET to enter the selected title entry mode.
Current character
entry position
Character entry section
6
7
8
2nd track
title
9
3rd track
title
Currently selected
character set
– 47 –
Press DISPLAY/CHARA to select the character set
you want.
• Each time you press the button, the character sets
change as follows:
Capital letters
Numerals
Input a character.
1) Press the character entry button for a character
you want to input.
Examples:
• To input an "A" or "a," press ABC once.
To input a "B" or "b," press ABC twice.
To input a "C" or "c," press ABC three times.
To input a "D" or "d," press DEF once.
To input an "E" or "e," press DEF twice.
To input an "F" or "f," press DEF three times.
............
• To input a symbol, press MARK repeatedly until
the mark you want appears.
• To move the character entry position while
entering a title, press ø or Ø.
• If you have entered an incorrect character, press
CANCEL to cancel the last entry.
2) Press the button for the next character you want
to input.
• If the next character you want to input is assigned
to the same button you have just pressed in step
, press Ø first to move the character entry
7-
1)
position to the right.
Repeat steps 6 and 7 to enter other characters.
• The main display can only show 8 characters at a
time. If you enter the 9th character, the first character
disappears, and so on.
Press ENTER to finish the current title entry.
"EDITING" appears for a while, then the unit enters
title entry mode again.
Small letters